Install your pvc fence panels on a weekend when the weather is nice and you are able to borrow a couple of your friends. Before you start, check the local building code office and see if you need a permit to install fences. Check with utility companies to see if there are some underground wire or gas lines buried in your yard. Check your survey to make sure you are planning your fence within your property lines and are not closing easements or rights of way.
Measure and participate in the pvc fence panels area. Place your corner bets a few inches beyond what you want the post. Then the chain is cut at the exact point of the post. The chain will give you a straight line to set your line poles. The line poles will go in each certain interval depending on the type of fence that is being installed. Most vinyl fencing is installed with panels. If this is the case, bets for your line poles can be set to the same extent as the length of the panel. Ends and corners are called terminal posts. The messages between them are known as line poles. Be sure to measure and adjust for the door or doors.
12 Photos Gallery of: Installing Pvc Fence Panels
Pvc fence panels, digging pole holes. Dig the terminal posts first. The hole should be 10 inches in diameter and one third of the length of the message, plus 4 inches in depth. Fill the 4 inches with gravel. Mark your messages with a colored pencil at the height where you want it to go on the floor. It is usually one third of the length of the message, but it is best to measure with the panel and be sure to get it accurate.