Fence post driver – A quality fence is as good as the messages. If you are building a fence or just creating a single decorative stand, this is how professional fence builders install wooden fence posts. Buy a pre-cut post or post without standard cuts. If you buy an uncut post you will need to protect from above rotting by rain drip the post with a 33 ° angle, a 45 ° cutting pyramid, or a back cover.
Fence post driver, cut the post to the correct height. Most home improvement stores and hardware stores sell 8 and 10 stands. For a 6 or 4 foot fence, you will need 7 and 9 standing positions. Cut the additional inches from the bottom of your post before. If you are building a 6-foot fence your messages should measure 74-76 inches above ground level, this allows a 2-inch space at the bottom of the fence pickets for a weed feed, and for avoid rotting the ground level. If you are going to add a back cover, leave 2 inches above the picket for mounting the lid.
12 Photos Gallery of: Best Fence Post Driver
Fence post driver, dig a hole with a diameter of 8 inches 3 feet deep. If you live in a northern state, where the freezing line is very strong, the rattle at the bottom of the hole to avoid agitated. Measure the length of your message and make a mark of the floor level in your post with a pencil. Set your wooden pole in the hole in a vertical position. Check to see if your mark on the ground is at ground level, if not adjust up or down accordingly.